Anyone attached a BuggyBoard to a Maclaren Tecno XT?

[BigAde]

Help!

I tried and failed yesterday (for over two hours I'm ashamed to say) to connect a BuggyBoard to our Maclaren Tecno XT. We got the connectors on okay, but they foul the folding mechanism of the buggy. We can't work out where on earth they would fit on the uprights... the only place we could find was too high for the board to connect to. I've put it on the old Mothercare pram for the moment, but it would make life SOOO much easier if it would fit on the Maclaren.

I've seen posts on here from people who've had them connected to a Tecno, so it sure must be possible (!) I'm probably just being thick, but would be very grateful for any help...

Thanks in advance.

no help sorry - but thought i'd bump this for u???

Thanks for the bump.

I'll have a quick look at mine (sorry in back of car), but we did phone the Rascals number (back of handbook), and they explained immediately

OK, they're attached just above the rear wheels (and just below the bar that folds int he middle when you fold the buggy), and the little connector rings "face forward", which if I recall correctly is where the instructions differ!

HTH

Thanks ladymuck, I'll check when I get home tonight.