Sinks...undermounted...drainer grooves...Belfast

[BeechTreeView]

At the moment in the plan it is unfermounted double sink with grooves.

But we'd like s decent sized sink...and I think I want a overmounted sink with a drainer.

Husband keen on indermounted and grooves.

Any experience?

We have an undermounted in our kitchen and I hate it. It’s really difficult to ensure it’s clean under the edge! When we did the matching utility I went for an oversized blanco stainless steel sink that could be undermounted or drop in. It has a very slim edge and you can get entire oven trays and shelves in it submerged! Rather than drainer grooves we have a separate stainless steel bar drainer accessory which you can use over the sink or on the worktop. We have paired it with a large curved tap with a pull out spout which is long enough to reach all corners of the sink!

That sounds good. I’ll look it up unless you have a link?

I have a blanco sink. It's a single sink really large. The biggest sink that would fit in a 600 unit. Kitchen fitter said beware of those with very sharp corners as they can be a pain to clean properly.......

This is pink but I'm not sure if this is the one with or without the point corners as that's what was picked first and then changed

https://www.tradingdepot.co.uk/blanco-zerox-550-u-stainless-steel-kitchen-sink-bl467708?oftid=MFRWG5B5GQZTOJTGMVSWISLEHUYSM4DSN5SESZB5GQ4DOMBQ&msclkid=f23450991387132e71bb3014a9dbbb89&utmmsource=bing&utmmedium=cpc&utmmcampaign=Blanco%20-%20Branded%20-%20Shopping&utmterm=4582077277495619&utmm_content=Blanco%20Zerox