Please or to access all these features

Chat

Join the discussion and chat with other Mumsnetters about everyday life, relationships and parenting.

Would you consider this a balanced load of washing?

83 replies

Roomination · 02/05/2024 16:26

It’s an 8kg capacity washing machine 1 double duvet cover
1 pillow case
1 bath towel (smaller size than a bath sheet)
3 pairs of pants.

i rang up to report a fault and was asked if I do balanced loads. Not really sure if the above is balanced or not. Thanks

OP posts:
PickAChew · 02/05/2024 23:55

You need a lot more than that in with a duvet cover or else it ends as one big lump that can't balance. Today, on a half load, I did a double and king duvet cover, 4 pillowcases, a pair of thick jammie bottoms, a few t-shirts and assorted knickers. It's a bulky load when dry but not heavy.

The whole point of a balanced load is that the weight can distribute around the drum. You also need to close the fastenings on the duvet covers so they don't swallow everything.

PickAChew · 03/05/2024 00:02

That balancing article is bonkers.

If. It's always tangling your stuff then it probably is a problem with the machine.

PickAChew · 03/05/2024 00:04

And it will be even more without the concrete weight!

Fizbosshoes · 03/05/2024 00:11

We have a 2 metre ceiling mounted dryer with 6 rails. I fill it up each wash, I couldn't begin to itemise what was in each wash!

Nat6999 · 03/05/2024 03:28

I do 2 King size duvet covers, 2 double fitted sheets, 1 flat sheet & 8 pillow cases in a 9kg washer. Never had a problem & my washer has a sensor for if the machine is overloaded.

NotARealWookiie · 03/05/2024 07:08

This is enlightening. I literally fill my machine to capacity.

RedHelenB · 03/05/2024 07:26

DelphiniumBlue · 02/05/2024 16:28

I'd say that's too much, I'd reckon to include the duvet cover or the towel, not both.

I put more than that in regularly and no issues with my machine.

Frizzyleaf · 03/05/2024 10:04

Not sure if it is the same for your machine OP, but mine (Bosch) can get into a loop of trying to shuffle an unbalanced load, then attempting to spin, detecting an imbalance, shuffling, attempting a spin, shuffle and repeat, and this makes the program take longer until it successfully rebalances and completes a full spin or gives up.

New posts on this thread. Refresh page