Meet the Other Phone. Only the apps you allow.

Meet the Other Phone.
Only the apps you allow.

Buy now

Please or to access all these features

Property/DIY

Join our Property forum for renovation, DIY, and house selling advice.

Is it possible to make a stud wall thinner?

6 replies

lolalotta · 08/07/2018 08:41

We are only 2.8cm short to fit a 1500mm P shaped shower bath in our family bathroom (we have a full size bath in our en suite too) is it possible to "steal" that 2.8cm from a stud wall does anyone know? There are 1400mm baths available but they are not wide in availability or choice and I'm not sure if they'd be suitable (wide/ roomy enough?) for a shower over them. I'm reluctant to just install a shower in the family bathroom as I'm not sure I want the little ones invading my en suite and am worried about resale! (though TBH we're not really thinking of moving for a long time) I HATE cleaning shower cubicles with a passion too!!!

OP posts:
johnd2 · 08/07/2018 13:22

Maybe, depends if the existing wall is 4 by 2 timber you could replace with 50 or 70 c section metal stud and get the space back.
You might be able to chase the wall out at both ends to get the space.
Noise transfer May be increased. It will also add to the cost.

ParisNext · 08/07/2018 13:28

As the previous poster said, you can make a stud walk thinner but realistically chasing into the brick or block at the other end would be potentially worth looking at. I had s cottage with a stone wall over a foot thick and took 4 inches away to make a bed fit longways in a small bedroom. It was not significantly loaf bearing and made no difference to the structural integrity.

ParisNext · 08/07/2018 13:29

Ha! LOAD bearing obviously...no Loafs were harmed...

bluerunningshoes · 08/07/2018 13:32

bth I would go with shower over a standard bath. much more choice.
make sure you use aquapanel below and around the shower at least (ideally throughout all walls/floor)

PigletJohn · 08/07/2018 18:52

don't chase into the wall. Buy a shorter bath.

Carron make baths in a surprising range of sizes. They are a bit more expensive, especially if you go for their extra-thick "Carronite" versions.

Have a look at the tech drawings and figures for water content. Many modern baths are designed with slopes and narrowness to minimise water content. Some of their models are designed to maximise roominess.

babyboyHarrison · 09/07/2018 14:45

Or have a look at Japanese soaking tubs. www.omnitub.co.uk. I fancy one as I like the thought of sitting up to my neck in water rather than lying down with my knees and boobs getting cold (maybe just me!). Just an alternative option to consider.

New posts on this thread. Refresh page
Please create an account

To comment on this thread you need to create a Mumsnet account.

This thread is closed and is no longer accepting replies. Click here to start a new thread.