Uniform Blazer pocket doesnt fit logo badge

132 replies

Faultymain5 · 01/09/2019 17:46

Where should I sew it.

DH suggested opposite side of the pocket (where there is no pocket).
I'm thinking one of the lower pockets where the badge does fit.

It just needs the badge on the blazer, the notes do not specify where, but it really doesnt fit the top blazer pocket where it would normally go.

OP posts:

SavoyCabbage · 01/09/2019 17:54

I'm doing my nampetapes right now and so I was about to measure the pocket only to discover....it's not a pocket at all!well, it's a working pocket but it's not a rectangle on the outside like yours.

Seeline · 01/09/2019 17:53

Yes to looking on the website to see what others have done.

I'd be tempted to remove the pocket, and put the badge in its place. You could always put the pocket on the other side if you wanted a pocket.

SavoyCabbage · 01/09/2019 17:51

Wow that really is too big. Presumably loads of people will be in the same boat. I think I'd want it on the correct side so it was less noticeable so I think I'd sew it on the pocket and sticking over the edges too. But without sewing the pocket closed.

littleducks · 01/09/2019 17:51

Though now I can see pics that's one large badge....what do kids on school website have? You sure you have right way round?

littleducks · 01/09/2019 17:49

You can't send kid with badge on the wrong pocket. That's just mean, can you switch blazer for one with larger pocket? Tbh I thought pockets were fairly standard sized until now

Original poster

Faultymain5 · 01/09/2019 17:49

Hopefully it attached this time

OP posts:

Original poster

Faultymain5 · 01/09/2019 17:47

Just so you can see how big it is. The logo goes from edge to edge.

OP posts:

Unflip

1 2 3 4 5 6