My sheets have come out machine with black spots

(11 Posts)
PigletJohn Sun 30-Dec-12 11:29:58

Please don't, you were probably right.

AfterEightMintyy Sun 30-Dec-12 11:26:34

hmm I'll just go and eat worms shall I?

Thanks, I'll try the hot wash & go from there. Luckily, I've just got most of our laundry up to date, so we should be ok not to use it for now.

BoffinMum Sun 30-Dec-12 10:01:15

Just seen what Piglet John said about bearings - funny noise would seem to make this likely so perhaps an engineer ought to have a look at it.

BoffinMum Sun 30-Dec-12 10:00:16

HG Service Engineer should sort this, or a 95 degree wash with biological soap powder and nothing in the machine.

PigletJohn Sun 30-Dec-12 09:36:55

If they are black mildew and come off when sponged, a service wash and scrubbing the soap drawer and its slot will ckean it.

However I think it is more likely grease from the drum bearings wearing out, will cause permanent staining so stop putting anything nice in it and look for a new machine (unless you have an extended warranty that will cover an expensive repair)

Thanks all. Sounds like a new machine might be on the cards then, but I'll try the hot wash with soda crystals & a cloth (thanks pepper, good idea!) and hope for the best.

Mintyy, I was going to say no about the spinning, then dh told me earlier, before I'd mentioned the marks, that it was making an odd sound this morning when spinning!

Blissfully, I was about to ask where I might find soda crystals, then I found some under the sink! smile

The machine was running all day yesterday, due to a vomiting, not quite night trained toddler, so perhaps it's protesting!

BlissfullyIgnorant Sat 29-Dec-12 15:13:02

You could try a couple of tablespoons of soda crystals in the drawer and run the machine on the hottest (95 deg) cycle either empty or with an old towel/small sheet/rag. I did it and it was ok but if the bearings are buggered you need an engineer. The soda crystals are a cheap first step, though.

AfterEightMintyy Sat 29-Dec-12 15:06:49

Its likely to be something called the bearings wearing out. I believe they had the drum in place. Have you noticed an increase in noise when the machine is spinning? On some machines they can be replaced relatively cheaply, but not on others and it often means that you will need a new machine.

pepperrabbitanddesultorytinsel Sat 29-Dec-12 15:03:04

You could run a proper machine wash - HG something? - product through, or there's a way of doing it really hot which someone will no doubt come along and be a bit more detailed about!
My helpful comment would be to add a towel or couple of old cloths when you do the service wash, an engineer gave me that advice as the cloth sloshing around the machine forces the water around through the holes a bit more. smile
When mine started to do this it turned out to be the beginning of the end though, as it was oil/grime from a bit of the drum that had moved or worn through.

Not many, but enough to be annoying. It's clearly the pattern of the holes in my machine drum. This hasn't happened before. So what is it, and what can I do to prevent it happening again? I'm assuming the machine needs some kind of maintenance wash, but I've never done one, & wouldn't know what to do!

Join the discussion

Join the discussion

Registering is free, easy, and means you can join in the discussion, get discounts, win prizes and lots more.

Register now